ART SUBMISSION GUIDELINE 

  Below is a list of requirements for sending your Art, Drawings, Blueprints, Hardcopies, and/or Camera Ready Art to MasterPress. If you do not have any of these options, MasterPress can design, engineer, and produce the necessary documentation needed to manufacture your custom label, overlay or membrane switch.

ART
   * Adobe Illustrator
   * Adobe Photoshop
   * EPS
   * JPG

DRAWINGS, BLUEPRINTS
   * DWG
   * DXF

HARD COPIES and DRAWING REQUIREMENTS
   * High quality paper and/or art board
   * The artwork must be sized 100% to 200% of the finished part with the final part size clearly specified.

   * Colors must be separated and the appropriate bleeds, registration and crop marks show clearly.
   * All fonts utilized should be specified.
   * Specification drawings should include die cuts, part and type sizes, color separations, reverses, etc.

CAMERA READY ART (FILM)
   * For front surface printed parts the film emulsion must be on the front surface, similarly for back printed parts the emulsion must be on the back side.
   * A reverse film must be supplied if more than 1-UP is run for the requested part.  For this film the front printed parts should have emulsion on the back side, and for back printed parts the emulsion must be on the front side.
   * Should your job require multiple colors, color-separated films with appropriate bleeds, registration and crop marks are required.
   * For screen tints and/or gradients print best at 65 dpi and while the results are not always consistent a dpi of 85 can be printed.